WATER RESISTANT MASCARA WITH LUXSIL
Preparation:Procedure 1. In a suitable kettle, slowly add xanthan gum into the vortex of water, using a low shear agitation. Disperse completely. 2. Pre-mix the remaining powder ingredients of Phase A in a blender type until the colour pigments are completely dispersed. 3. Start heating the batch to 60°–70°C. Then add the pre-mixed pigments and the remaining ingredients of Phase A into the batch. 4. Mix well every each ingredient addition. Hold the temperature while the batch is constantly mixing. 5. After ten minutes of mixing, pass Phase A into homomixer and homogenize the batch for 5 minutes or until uniformly dispersed. 6. Change the mixing into propeller mixing and bring up the temperature to 80°–84°C. 7. In a separate kettle, combine Phase B materials and heat to 80°–84°C. 8. When both Phases are at the same temperature, add Phase B to Phase A applying moderate agitation. 9. Start cooling at 45°–40°C. Add the premixed Phase C into the batch. 10. Continue mixing until it reaches to 35°–30°C. 11. Pour into appropriate containers.
While every effort has been made to reproduce these formulations correctly, the Publisher of this website cannot accept any liability for the information presented. All formulations are provided in good faith, but no warranty is given as to accuracy of information or results, or suitability for a particular use, nor is freedom from patent infringement to be inferred. Formulations are offered solely for consideration by the participating manufacturers. Continued use of this web site infers acceptance of this disclaimer.