TOOTHPASTE FOR SENSITIVE GUMS
Preparation:Production Method Preliminary phases Phase C: Mix the ingredients until homogeneity; Phase E: Dissolve the powder into water until clear solution, under cupboard; excessive foam formation must be avoided. Phase F: Mix the ingredients until clear solution; Addition scheme 1) In the main mixer add ingredients A and mix with blades until clear solution. Then add A1 and homogenize with turbine and blades under vacuum for 10'. Successively heat the phase to 65°C under vacuum. At this temperature, homogenize with turbine and blades under vacuum for 10'. Sample and check homogeneity. 2) Add, in sequence, B and phase C and homogenize with turbine and blades for 10’ after each addition. 3) Add, in sequence, ingredients D and homogenize with turbine and blades for 10’ after each addition. Check homogeneity of the mix after each addition. 4) Add, in sequence, E and phase F while mixing with blades under vacuum for 5’ after each addition. Sample product for analytical controls.
While every effort has been made to reproduce these formulations correctly, the Publisher of this website cannot accept any liability for the information presented. All formulations are provided in good faith, but no warranty is given as to accuracy of information or results, or suitability for a particular use, nor is freedom from patent infringement to be inferred. Formulations are offered solely for consideration by the participating manufacturers. Continued use of this web site infers acceptance of this disclaimer.